Operation
Runco LS-10d and LS-10HBd Installation/Operation Manual
73
PRE
L
IMINAR
Y
2.
Highlight
Enable
and press
ENTER
.
3.
Highlight
On
and press
ENTER
.
4.
Press
MENU
.
5.
Highlight
Timer
and press
ENTER
.
6.
Press
or
to set the notification interval in months. The range is from 1 to
255 inclusive; the default is 12 months.
7.
Press
MENU
.
•
Lamp Life Notification:
To have the DHD Controller send a message to the
destination e-mail address when the lamp hour counter reaches a certain threshold,
select Lamp Life Notification from the E-Mail Notification menu. Then:
1.
Highlight
Enable
and press
ENTER
.
2.
Highlight
On
and press
ENTER
.
3.
Press
MENU
.
4.
Highlight
Lamp Hour
s
and press
ENTER
.
5.
Press
or
to set the notification threshold in hours. The range is from 100 to
10,000 hours; the default is 1,000 hours.
6.
Press
MENU
.
•
Cu
s
tomer Information:
Select Customer Information from the E-Mail Notification
menu to supply this information to the DHD Controller, which includes it in all e-mail
notification messages. Six lines (up to 30 characters per line) of text are provided;
use them however you wish.
1. Press
or
repeatedly to select a line of text to edit.
2. Press
ENTER
.
3. Press
or
repeatedly to set the highlighted character.
4. Press
(or
) to select the next (or previous) character. Use the
and
buttons to change it.
5. Press
ENTER
when you have finished editing that line of text.
6. Repeat Steps 1 through 5 for each line of text you want to edit.
7. Press
MENU
when you have finished entering customer information.
•
E-Mail Calibration Data:
To have the DHD Controller collect all calibration data,
attach it to a message and send it to the destination e-mail address, select E-Mail
Calibration Data from the E-Mail Notification menu. To confirm this action, select
Ye
s
and press
ENTER
.
To cancel and return to the previous menu, select
No
.
• Remote Networ
k
Control:
Select Remote Network Control from the Network menu
to enable or disable control of the DHD Controller via an IP connection (typically using a
web browser). Set it to
On
to allow all incoming remote network connectivity. Set it to
Off
to disable any incoming network communication that was not initiated by the DHD
Controller.
This setting has no effect on the E-Mail Notification or Auto
Firmware Upgrade functions.
Note
Summary of Contents for LIGHTSTYLE LS-10D
Page 2: ......
Page 10: ...x Runco LS 10d and LS 10HBd Installation Operation Manual P R E L I M I N A R Y Notes ...
Page 125: ......
