48
Mounting the Access Point
Step 2: Attach the Dynamic Bracket to the Access Point
3.
Using a 6mm Phillips screwdriver, tighten the four machine screws to fasten the bracket
to the Access Point. Screw torque value must be 0.4-0.5 Newton meter (Nm).
4.
Continue to
“Mounting the Access Point”
in the next section.
8
Mounting the Access Point
To mount the Access Point, you will need to join the two mounting brackets that you
attached earlier to the device and the mounting surface. For this procedure, you will need
the following items:
■
Hex bolts
■
10mm ratchet wrench
NOTE:
Figures in this section show mounting on a vertical pole. Procedures for mounting
on a flat surface or horizontal surface are similar.
To join the two mounting brackets together:
1.
Join the two brackets as shown in
Figure 39
. Make sure that:
•
The dynamic bracket (attached to the Access Point) encloses the static bracket
(attached to the mounting surface).
Summary of Contents for ZoneFlex 7762-T
Page 2: ......
Page 62: ...58 What to Do Next Read Related Documentation...
