53
Resetting the Access Point to Factory Default Settings
Configuring the 5GHz Antenna Gain
4.
Scroll down to the
Radio A/N (5.0 GHz)
section of the form.
5.
Verify that
WLAN Service
check box is selected. The WLAN service must be enabled
before you can configure the antenna gain.
6.
Select the check box after
External Antenna
, and then enter the antenna gain value
(in dBi) in the box provided.
7.
Click
OK
at the bottom of the form to save your changes.
You have completed configuring the 5GHz antenna gain from the ZoneDirector Web
interface.
Figure 41.
Configure the external antenna gain
10
Resetting the Access Point to Factory
Default Settings
You can reset the Access Point to its factory default settings by shorting pins 3 and 4 on
the DC connector. Use the electrical shunt that is provided with the Access Point package
to perform this procedure.
NOTE:
The Access Point can only be reset to factory default if it is using PoE.
1.
Verify that the Access Point is using PoE as its power source.
2.
Take out the electrical shunt that is supplied with the Access Point.
3.
If the DC connector on the Access Point is protected by its cap, remove the cap. Take
note of the location of pins 3 and 4 (see
Figure 42
).
Summary of Contents for ZoneFlex 7762-T
Page 2: ......
Page 62: ...58 What to Do Next Read Related Documentation...
