208
Appendix
Appendix
Modulation
fig.AlgoStCho.eps
his is a stereo-in, stereo-out chorus. It lets you apply chorus
without impairing the position of the sound image that’s been
set for the stereo input, by panning or other means.
Chorus
RATE
Chorus rate
Value:
0.1–10.0 Hz
DEPTH
Chorus depth
Value:
0–100
Pre Dly (Pre-delay)
Time until the chorus sound is output
Value:
0–100 ms
XMIX (Cross mix)
Mix amount for the opposite-side chorus
Value:
-100–100
DIR SW (Direct switch)
Turns the unprocessed sound on/off
Value:
OFF, ON
EFF SW (Effect switch)
Turns the effect sound on/off
Value:
OFF, ON
fig.AlgoStFlang.eps
This is a stereo-in, stereo-out flanger. It lets you apply flanging
without impairing the position of the sound image that’s been
set for the stereo input, by panning or other means.
Flanger
RATE
Flanger rate
Value:
0.01–10 Hz
DEPTH
Flanger depth
Value:
0–100
MANUAL
Center frequency at which the flanger effect is applied
Value:
0–100
LFO PHASE
Phase difference between L and R for the LFO (Low-Frequency
Oscillator)
Value:
-180–180 deg
FB (Feedback)
Amount of flanger sound that is returned to the input of the
flanger
Value:
-100–100
XFB (Cross feedback)
Amount of flanger sound that is returned to the opposite-side
input of the flanger
Value:
-100–100
LEVEL
Flanger level
Value:
0–100
DIR SW (Direct switch)
Turns the unprocessed sound on/off
St.CHORUS (Stereo Chorus)
Input L
Input R
Chorus L
Output L
Output R
DIR SW
Chorus R
DIR SW
EFF SW
XMIX
EFF SW
St.FLANGER (Stereo Flanger)
Input L
Input R
Flanger L
Output L
Output R
DIR SW
Flanger R
XFB
FB
FB
DIR SW
EFF SW
EFF SW
M-300_e.book 208 ページ ２０１０年４月２２日 木曜日 午前８時１７分
