![background image](http://html1.mh-extra.com/html/royal/1632rec-s/1632rec-s_manual_1494074022.webp)
22
Position the step unit in its desired location within the pool frame.
Temporarily secure the step flanges to the wall flanges with C-
Clamps as shown here.
Working one side at a time, adjust the position of the step to ensure
that the top of the step will be level with the top of your coping
(NOT the top of your wall panel). This level can be equal or slightly
greater than the maximum height of the coping that will be used.
•
Bullnose Steps: The top of the step should be flush with the top of your bullnose coping.
Since actual coping size can vary you should measure the coping or actually place the
coping on the wall before drilling the attachment holes.
•
Cantilever Steps: The top of the step should be flush or slightly higher with the top of
the wall panel.
Once your step is aligned correctly in relation to your wall
panels, clamp the step in place securely. Using the holes in
the wall flange as a template, drill matching hole into the
step flange. Secure the wall panel and step together in these
locations with bolting.
The back of the step must be supported. Supports can also be used to level the step as well. The
step should be leveled to the same slope as the deck which will slope away from the pool.
Step supports typically come in one of two forms: A Brace or a Pole
BRACE STEP SUPPORT
POLE STEP SUPPORT
IMPORTANT! The bolt
heads, with an oversize
washer under them
MUST be on the step side
of the flange assembly.