Roxell Optimax, Use And Assembly Manual

Page: 55 / 92

ROXELL - 004 - 3911 OPTIMAX -- INSTALLATION INSTRUCTIONS
III--1
GENERAL SAFETY RULES
IMPORTANT
This
SYMBOL
will be used to draw your attention to matters that
are of
GREAT IMPORTANCE
for your
SAFETY
.
It means :
WARNING
- follow the safety instructions :
disconnect the current - re-read the safety rules.
In short :
BE ALERT
.
IGNORING these instructions can cause SERIOUS INJURIES
or even DEATH.
Carefully read the following instructions
before you
INSTALL
the system
1.
Be
CAREFUL
when handling the
ROLLS OF AUGER
.
-
When you release the
BINDING WIRE,
it is possible that the auger
UNROLLS
.
This can cause injuries.
-
ALWAYS
use
SAFETY GLOVES
when you slide the auger into the tube.
-
ALWAYS
see that the auger
CANNOT SPRING BACK
(by using clamps)
when you put it under tension .
2.
Check all
TUBE CONNECTIONS
and all
TUBE CLAMPS
on control units, feed
intake boots and bearings for
PROPER CLAMPING.
Tighten all tube clamps with
a
TORQUE
of min. : 10Nm.
3. TEST
the
SUSPENSION SYSTEM
for safe operation :
-
Firmly fasten the
WINCH
and the
SUSPENSION POINTS
. Firmly tighten
ALL
CABLE CLAMPS
.
-
WINCH UP THE FEEDER LINES THREE TIMES
and lower them again (full
course).
NEVER STAND UNDERNEATH THE SYSTEM
when doing this.
-
Winching up and lowering must proceed
WITHOUT ANY HITCH
.
4.
At the
FIRST START UP,
make sure that, if the auger
HITCHES
or
BLOCKS
,
you can
IMMEDIATELY SWITCH OFF
the system with the main switch on the
control panel.
DANGER