Rotenso J100Wi, Service Manual

Page: 69 / 132

LCAC R32 Series
69 Service manual
5.2.5 Insulate the copper pipe
• Before test operation, the joint parts should not be heat insulated.
5.2.6 Flare the pipe
• Insert a flare nut into the pipe before flaring the pipe
• According to the following table to flare the pipe
Pipe diameter
Flare dimension A (mm)
Flare Shape
Min Max
1/4” (6.35) 8.3 8.7
R0.4~0.8
A
45°
90 ° 4
-+
3/8” (9.52) 12.0 12.4
1/2” (12.7) 15.4 15.8
5/8” (15.9) 18.6 19.1
3/4” (19) 22.9 23.3
• After flared the pipe, the opening part must be seal by end cover or adhesive tape to avoid duct or exogenous
impurity come into the pipe.
5.2.7 Drill holes if the pipes need to pass the wall.
5.2.8 According to the field condition to bend the pipes so that it can pass the wall smoothly.
5.2.9 Bind and wrap the wire together with the insulated pipe if necessary.
5.2.10 Set the wall conduit
5.2.11 Set the supporter for the pipe.
5.2.12 Locate the pipe and fix it by supporter
• For horizontal refrigerant pipe, the distance between supporters should not be exceed 1m.
• For vertical refrigerant pipe, the distance between supporters should not be exceed 1.5m.
5.2.13 Connect the pipe to indoor unit and outdoor unit by using two spanners.
• Be sure to use two spanners and proper torque to fasten the nut, too large torque will damage the bellmouthing,
and too small torque may cause leakage. Refer the following table for different pipe connection.
Pipe diameter
Torque
Sketch map
(kgf.cm) (N.cm)
1/4" (6.35) 144~176 1420~1720
3/8" (9.52) 333~407 3270~3990
1/2" (12.7) 504~616 4950~6030
5/8" (15.9) 630~770 6180~7540
3/4" (19) 990~1210 9270~11860
PART 4. INSTALLATION