Rotary SPO16, Installation Instructions Manual

Page: 5 / 32

5
Concrete and Anchoring:
Drill (14) 3/4" dia. holes (7 per side) in concrete floor using holes
in column base plate as a guide. See diagrams for hole depth,
hole spacing, and edge distance requirements.
CAUTION
DO NOT install on asphalt or other similar
unstable surfaces. Columns are supported only by anchors in
floor.
Run nut down just below impact
section of bolt. Drive anchor
into hole until nut and washer
contact base.
Drill holes using 3/4” carbide
tipped masonry drill bit per
ANSI B212.15-1994 (R2000).
Construction dust collected
per OSHA 29 CFR 1926.1153.
Tighten nut with Torque
wrench to 110 ft.-lbs
.
CONCRETE AND ANCHORING REQUIREMENTS
STANDARD ANSI/ALI ALCTV IBC SEISMIC
Minimum Floor Thickness 4-1/4 INCHES 5 INCHES 6 INCHES Varies by location consult
with your structural engineer
and manufacturer’s
representative.
Anchor Hilti Kwik Bolt III
3/4" x 5-1/2"
Anchors supplied
with the lift.
*
Hilti HIT-HY 150
MAX-SD Adhe-
sive; Hilti HIT-HY
150
MAX Adhesive;
HILTI HIT-RE 500-
SD Adhesive
Hilti Kwik Bolt III
3/4" x 7"
Minimum Concrete
Strength
3000 PSI 3000 PSI 3000 PSI
Minimum Anchor Embed-
ment
3-1/4 INCHES 3-1/2 INCHES 3-3/4 INCHES
Minimum Distance to
Concrete Edge, Crack,
Expansion Joint, Aban-
danoned Anchor Hole
4-1/2 INCHES 5-1/4 INCHES 3-1/4 INCHES
*The supplied concrete fasteners meet the criteria of the American National Standard
“Automotive Lifts - Safety Requirements for Construction, Testing, and Validation” ANSI/ALI ALCTV-2017, and the lift
owner is responsible for all charges related to any additional anchoring requirements as specified by local codes.
Contact customer service for further information at: 800.445.5438