17
WARNING
(2) qty. 10" adapter extensions and (4) qty.
5" adapter extensions are supplied with each lift. These
extensions should not be stacked more than 15" high.
24. Upon completion
of the assembly of the lift, the lift
is to be operated to assure proper function. Observe
for locks operating in all locking positions, each side
lifts equally, hydraulics do not leak, all electrical
controls function as labeled, all pneumatics are functional
and leak free, ramps rotate freely (if applicable), and
proper clearances with all items in bay have been
maintained.
Operate the lift with a typical vehicle and observe to
assure the same items for proper functioning.
19. Door Bumper Installation:
1) Press bumpers on column edge and carriage, Fig. 25.
Note:
Door Bumpers may need to be installed in different
areas depending upon type(s) of vehicles used. The
above installation is the most recommended.
20. Pressure Test:
Run lift to full rise and keep motor
running for 5 seconds. Stop and check all hose connec-
tions. Tighten or reseal if required. Repeat air bleeding of
cylinders.
21. Final Adjustments:
Raise lift to check equalizer cable
tension. Below carriage, grasp adjacent cables between
thumb and forefinger, with about 15 lbs. effort you should
just pull the cables together. Adjust at upper tie-offs, Fig.
15.
22.
Decal Location:
Install enclosed pinch point decals.
Place (1) decal on each column, Fig. 26.
Fig. 25
23.
Adapter Rack:
Install adapter rack, Fig. 27. Place
extension in racks.
21"
Door Bumpers
Place WARNING decal
a minimum of 8" from
the bottom of the decal
to the ground.
WARNING
Keep feet
clear of lift
while lowering
WARNING
Keep feet
clear of lift
while lowering
(2) 10" Extensions
(2) 5/16" x 3/8" Lg.
Pan Head Screws
(4) 5" Extensions
Adapter Rack
Fig. 27
Fig. 26
Summary of Contents for SPO16
Page 31: ...31 Notes...
