Rotary SGL35M, User Manual

Page: 29 / 51

11. Installation
27

Disconnect the cable from the 400 V terminal on
the transformer and connect it to the 230 V
terminal.

Remove the cover of the motor terminal box.

Loosen the M5 lock nuts on the terminal strip
and change its position (Fig. 23)

Tighten the M5 lock nuts again and replace the
terminal box cover.
To prevent any danger arising from the power
supply, tighten the control unit cover before
connecting the control unit to the power supply.
To prevent use of the lift by an unauthorised
member of the staff, lock the main switch of the
control unit.
Connect the control unit to the power supply.
23
CAUTION
Grounding

The ground connector is essential to proper
operation of the lift.

NEVER ground to gas, water, telephone, or
other lines which are not expressly intended
for grounding.
11.5 Final assembly of the
mechanical unit
a) Installing the synchronisation cables
The synchronisation cables and the lock
cable are fully installed with the columns in an
upright position.
To do so, the slider blocks must be set up at
the same height in the centre of the vertical
travel and engage the rack teeth.
Now go back to Figure. Fehler!
Verweisquelle konnte nicht gefunden
werden.
and proceed as follows:

Check that the cable is properly routed. Fit the
short cable clamp of the metal cable (Pos. 95)
to the slider block with a washer (Pos. 96) and a
self-locking nut (Pos. 97).

Repeat this procedure on the opposite column.

Take the long cable clamp and fit it with a
washer and a self-locking nut.

Do the same with the second cable.

Carry out a final adjustment as per section 12 to
check that the two cables are equally tensioned.
b) Assembling the latch mechanism

Assemble the latch mechanisms according to
the drawings on page 42.
i
i
i