4.
Safety
regulations
10
4.
Safety regulations
Comply with the following regulations!
4.1 General operation
Only operate the lift if you have read and
understood this operating manual. Also refer to
the brief operating instructions on the lift.
The total permitted weight is 3,500 kg .
Only persons who are 18 years old, are trained
in operating the lift, and have signed the
handover sheet are permitted to operate the lift.
Vehicles with low ground clearance or with
optional extras should be checked beforehand.
They can only be lifted if no damage can be
caused.
Work on the lift may only be carried out if the
main switch is turned off and locked.
Do not:
Carry people on the lift.
●
Climb onto the lift or the load.
Ride on the lift with equipment.
Emergency lowering of a vehicle may be done
only by competent persons.
Switch off equipment when not in use.
Do not use the lift in proximity to a potentially
combustible or flammable atmosphere.
4.2 Operational safety,
breakdowns
The operational safety of the lift must be
inspected regularly.
If breakdowns occur or if there are missing
safety components, shut down the lift
immediately. Inform the supervisor or customer
service.
4.3 Picking up loads
Before lifting with the arms, check the pick-up
points on the vehicle for load capacity,
corrosion, damage, and modifications.
Only lift vehicles at
the points approved by the
manufacturer.
Do not carry out any work on a raised vehicle
which may affect the stability of the pick-up
points.
4.4 Up /down
Only operate the lift if it poses no danger to
people.
During the raising and lowering process, no-one
should loiter within range of the moving load
and the pick-up points.
Briefly raise the lift to check that the vehicle
pick-up points are secure. The latches must be
properly engaged. Only then lift the vehicle to
the desired height. The lift and the vehicle may
otherwise become dangerously unstable.
The area within range of moving loads and pick-
up points must be free of obstacles.
4.5 Installation, maintenance,
servicing
Installation, maintenance, and servicing work
may only be carried out by trained and
authorised specialists, with the system switched
off and made safe.
Electrical work may only be carried out by
qualified electricians.
Only specialist staff with specialist knowledge
and experience may work on hydraulic
equipment.
Repairs on the safety equipment of the lift may
only be carried out by competent persons.
Follow the maintenance schedule, document
maintenance work.
Only use OEM parts.
Following design modifications or repair work on
safety relevant parts, the lift must be inspected by
a certified expert.
Adapter Recommendations
Most specialty or modified vehicles cannot be
raised on a frame engaging lift. Contact vehicle
manufacturer for raising or jacking details.
WARNING
This style adapter recommended for
lifting Unibody Vehicles.
This style adapter recommended for
lifting Frame, Stub Frames, and
Perimeter Frame Vehicles.
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
Summary of Contents for SGL35M
