56
Fine adjustments to the latch bars and cables
1. Ensure that no vehicle is on the lift or the lifting
table (lift is unloaded).
2. Raise the main lift by around 1 m with the Up
button.
3. Lock the main lift into the latch bars with the Lock
button. Make sure that it latches into all 4 latch
bars.
4. Switch main switch to OFF.
5. Remove the top nut (6) of the cables.
6. Adjust the threaded sleeves (4) of the cables
(5) on all 4 lift columns so that the cables are
completely slack.
7. Loosen the lock nut (1) of the latch bars.
8. Place markers A and B on the driving surfaces.
9. Using the automatic level, measure the distances
between markers A and B for each lift column.
10. Using the adjusting nuts (1) adjust all 4 latch
bars so that the two driving surfaces are aligned
with a crosswise height tolerance of:
± 1 mm and diagonal tolerances of ± 2 mm.
11. Tighten the adjusting nuts (1) of the 4 lift
columns (lock them).
12. Then secure the lock nut(1) at the top .
49
3
1
1
Bottom of Slot
Fig. 11
2
4
5
6
13.Tension the threaded sleeves (4) of the cables
(5) on the 4 lift columns slightly.
14.Turn the main switch to ON and lower the main
lift to the floor.
The lifting tables are already height adjusted .
ex works and do not need to be leveled.
50
i
6
1
5
3
2
4
1
For SM40-47-BMW
