21
Raising the lift
1. Set the selector to the left (main lift).
2. Lift the main lift slightly with the UP button.
3. Check the steadiness and pick-up stability of the
vehicle.
4. Only start to lift smoothly and to the required
height if the vehicle is stable.
Destruction of the hydraulic pump.
Operating error, when the main lift
is moved for long periods to its full
rise.
Only move the lift to just below its full rise.
Then release the button.
5. Lower the main lift with the "Lock“ button to the
lock position.
Comply with occupational health & safety and
accident prevention regulations. Use safety
stands when disassembling heavy parts.
Check that weight distribution is correct.
Raise the lifting table
6. Set the selector to the right (lifting table).
7. Check the position of the supports or pads and
correct if necessary.
8. Lift the vehicle slightly with the Up button.
9. Proceed as described above (Pos. 3 to 5).
Lifting with a slack cable
If the main lift is on the skew, the slack cable
switch activates a stop. Only the lift function
is still active.The buzzer sounds continuously
throughout the lifting. The lift function is also
locked if the cable breaks.
If the cable is slack, press the Up button.
Raise the lift so that all 4 cables are
tensioned.
Lowering the main lift or lifting table
1. Remove all objects in the lift and lifting table
zone, in particular under the lift and lifting table.
2. Set the selector to the desired position.
3. Using the Down button, steadily lower the lift or
the lifting table until the automatic shut-off (120
mm) is activated.
To do so, first move the runways up for around
2 seconds to release them from the ratchets.
Only then move the runways down until the au-
tomatic shut-off is activated. The lowering proc-
ess stops.
When lowering, make sure that the main lift
lowers smoothly. If not then stop the process.
If the main lift is skew, move it upwards slig-
htly so that the cables pull tight..Then conti-
nue the lowering process.If this does not
work, consult a competent person.
4. To completely lower the lift press "Lock“ and
"Lower in the danger zone“ together.
Move the main lift or lifting table right to the bot-
tom position. Make sure that the drive-on ramps
are fully lowered.
4.6 Drive off
1. Remove chocks.
2. Carefully drive the vehicle off the lift and away
from the lift area (have someone to guide you).
In doing so, make sure that the wheels never run
over the edge of the runways or alongside them.
4.7 Switch the machine off
1. Disconnect the power supply with the main switch
("OFF“setting) and lock the switch with a padlock.
i
i
i
i
