48
Tightening torque table in Nm where µ = 0,12
Thread
Property class
5.6 8.8
10.9 12.9
M 4
1.3
3
4.6
5.1
M 5
2.7
5.9
8.6
10
M 6
4.7
10.1 14.9 17.4
M 8
11.3 24.6 36.1 42.2
M 10
22.9 48
71
83
M 12
39
84
123 144
M 14
62
133 195 229
M 16
96
206 302 354
M 18
133 295 421 492
M 20
187 415 592 692
4. Check diagonal length. Correct the alignment if
necessary.
11.9 Assemble the lift column
Proceed as follows on all 4 lift columns.
Make sure the lift column with the control unit is
correctly positioned.
1. Set down the lift column onto the assembly
position with a forklift truck.
2. Slide the lift column from the back onto the
crossbeam and align approximately with a plumb
line.
3. Equalize greater differences in height with shims
(
→
optional accessories). Make sure there is no
differences in height between the lift columns
(max. height difference between the 4 lift columns
= 5 mm).
4. Fasten the right and left slider blocks G to the lift
column each with 2 bolts. Then slide the latch bar
into the slider blocks.
37
A
G
G
K
CAUTION
Make sure the bolts for the slider
block G are tight all the time, when
you install it ,please add thread-
locking adhesives.
5. Mark the 4 anchoring holes on the floor and for
each lift column and drill (Ø 16 mm, 130 mm
deep). Clean the drill holes.
6. Insert all 16 anchor bolts into the holes. Use a
rubber mallet if necessary.
Approved anchor bolts
Manufacturer
Type
Thread
MKT
Anchor bolt BZ plus M16
MKT
Anchor bolt BZ plus M16
A4 or HCR
MKT
Injection system 105/M16
VMZ (chem.)
125/M16
145/M16
HILTI
HVZ (chem.)
M16x105
HILTI
Through bolt anchor M16
HST, HST-R and
HST-HCR
Fischer
Anchor bolt FAZ II M16
Fischer
High-bond anchor M16x95
FHB II (chem.)
Würth
FAZ
M16
Anchor bolt clamping zone
The clamping zone for these anchor bolts is
the sum of the non-bearing flooring plus the
thickness of the column base plate of 10 mm.
i
Drill holes Clean holes Run nut down
just below
impact section
of bolt.Drive
anchor into
hole until nut
and washer
contact base.
Tighten
nut with
Torque
wrench
