Connection and Configuration
Once you have constructed the Comlink adapter cable, connect it and configure the PC as follows:
1. Connect the cable between your PC’s serial port and BNC 7 on the rear panel of the
ADC-8032A.
2. With the custom cable properly connected, set up your PC’s serial port parameters as
follows:
•
19.2 K baud rate
•
8 data bits
•
No parity
•
1 stop bit
•
No flow control
3. On your PC, run a program that uses VT-100 terminal emulation, such as
Terminal.exe
or
HyperTerminal
. With the ADC-8032A powered up, you should
now have all setup parameters visible on the PC, as illustrated in the sample screen
below.
Figure 9. Sample Terminal Display
ADC-8032A User Manual (Iss. 04)
Comlink
•
6-3