Bank C-8: Freeze Mode
The input image can be frozen (
ADC-8032A-S
only) if any of the following conditions occur:
•
The user selects Manual Freeze (
Forced Freeze
,
Bank C, Position 9)
•
There is a loss of input signal (
Input Loss Mode
,
Bank C, Position A)
•
A hotswitch occurs (
Hotswitch Mode
, Bank C, Position B)
The
Freeze Mode
function allows you to set the
type
of freeze that occurs: Field 1, Field 2, or Full
Frame. Use the following steps to set the freeze mode:
1. Select Bank C, and rotate
Function Select
to position 8.
2. Select the desired mode according to the table below:
•
Toggle
Mode Select
up
to advance up the list.
•
Toggle
Mode Select
down
to descend down the list.
Bank SW1 Function Select SW2 Mode Select
Heads-Up Display Label Default
C
8
+ Frame
Field 2
- Field 1
FRZ MODE
FRAME
FLD 2
FLD 1
FLD 1
Bank C-9: Forced Freeze
The output can be
manually
frozen (
ADC-8032A-S
only) using the
Forced Freeze
mode. When
enabled, the freeze will affect either field 1, field 2 or the entire frame (as determined by the
Freeze
Mode
function).
Use the following steps to enable or disable the Forced Freeze mode:
1. Select Bank C, and rotate
Function Select
to position 9.
2. Select the desired mode:
•
Toggle
Mode Select
up
to freeze the image. The
FREEZE
LED is on.
•
Toggle
Mode Select
down
to un-freeze the image, and allow input video to
pass through. The
FREEZE
LED is off.
Bank SW1 Function Select SW2 Mode Select
Heads-Up Display Label
Default
C
9
+ Freeze
- Pass Through
FREEZE FORCE
PASS
PASS
ADC-8032A User Manual (Iss. 04)
Using Banks
•
4-19