Chapter 2: Hardware Installation
Hardware Installation
2-9
Figure 2-7: Installing a Drive Tray
Step 4.
Close the front flap on the drive tray.
Make sure the front flap is closed
properly to ensure that the SCA connector on the MUX kit at the back
of the drive tray is firmly connected to the corresponding connector on
the backplane board. If the front flap is not closed properly, the
connection between the hard drive and the subsystem will not be secure.
Figure 2-8: Closing the Drive Tray Front Flap
Step 5.
Lock the flap into place
by turning the key-lock until the groove on its
face is pointing down (vertical orientation). (See
Figure 2-9
)
