Ronald 42212TNI, Installation Manual

Page: 15 / 68

15
Collect the following components:
1. Dahua camera on junction box with tripod mount and Ethernet connector.
2. Surveyor-style tripod
with 5/8”-11 threaded mount.
3. Planet POE171 single-output, 60W injector or a FSD-504HP four-output, 60W
PoE power injector with power supply and line cord. Note : These cameras
cannot be used with a POE164 Injector due to its lower, 30W output power. The
POE164 may be used with the N53AB52 camera.
4.
Ethernet 6’ cable
5.
Ethernet 100’, 196’ or 300’ all-weather cables.
Note : The maximum length for a
camera to injector cable is 100 meters or 328 feet.
6. Optional castor cups to protect a floor from the tripod tips.
Setup Procedure:
1. Open the tripod in the selected location. Remove the protective cap on the tripod
threads.
2. Place the camera assembly on top of the tripod and using the knob under the
tripod, screw the tripod treads into the bottom of the camera assembly. The
assembly does not have to be precisely located at the center of the top of the
tripod.
3. The initial height of the camera may be adjusted by spreading the tripod legs and
by how far the legs are extended. To extend them, unlatch, extend/retract and
re-latch. For stability, it is better to spread the legs to a wider rather than
narrower stance and extend the legs if necessary to achieve a desired height.
4. To protect your carpet or flooring, optionally place a castor cup under each of the
three legs.