34
ETHERNET CABLE CONNECTIONS
1. Connect the waterproof Ethernet cable to the connector on the mounting box as
shown below. To do this, start with all parts of the connector housing unscrewed.
Plug the Ethernet cable connector into the box connector until the latch snaps in.
Move the larger connector housing toward the connector and screw it all the way
onto the box connector. Verify that the rubber cable gland is fully inserted into
the back of the housing. Then move the farther portion of the connector housing
toward the cable box and screw it onto the connector body. Be careful not to
cross-thread this connector. If it does not screw in exactly straight, then unscrew
it and try again. Cables provided by UFODAP come with this backshell installed
on the cable.
2. Your PoE Injector passes the Ethernet signals thru it to your router while
“injecting” DC power on two unused cable wire pairs to power the camera. To
install it, place the PoE injector near your router. For a four-port injector, plug the
injector barrel power connector into the rear of the injector. Plug the injector line
cord into the injector
’s power supply and plug the line cord into a source of AC
power. The power supply is rated for 110/240 VAC
– 50/60 Hz power so if the
Summary of Contents for 42212TNI
