41
Basics
PROGRAMMING
1.4 Direct access to specific slides in the
»auto« and »test« modes
As in the »manual« mode, direct access to all
slides in the working memory is also possible
in the »test« and »auto« modes. The run can
be started in three different ways:
»
1. By pressing the green forward button.
»
2. By accessing a slide slot using the
»focus« buttons
15
and then pressing the
green forward button
19
.
»
By entering the number of the slide slot
on the numerical keyboard and pressing the
green forward button
19
.
The projector will then search for the pro-
gram number under which the selected slide
number is logged. This and the slide registe-
red under the following program number will
be moved into the projector.
»
During a slide show, direct access is pos-
sible at any time using the keyboard and then
pressing the green forward button
19
.
In this case, the slide in the standby position
is exchanged for the one selected and then
faded in.
NOTE:
Direct access is possible in the »auto« and
»test« modes only if the slide selected does
exist in the working memory.
NOTE:
An uninterrupted show of over 100 slides can
be assembled only with type CM 55/50 Rollei
hook-up magazines. If such a show is to start
with slide (slot) number 175, for example,
first enter the figure 175 via the keyboard
and then press the green forward button
19
.
As a result, the magazine will not advance by
175 slide slots, but only by 25 - the projector
assuming that the magazine with slides 151
to 200 is in place. The projector will start
operating that way beginning with slide (slot)
number 101.