1.2 Running a test
A manually controlled slide show can imme-
diately be repeated automatically for testing
purposes.
»
To do this, switch on the »test« mode
by pressing the »mode« button
35
after the
end of the show.
»
Playback can be started immediately by
pressing the green forward button
19
.
»
Use the »stop/go« button
16
to stop
and restart a dissolve or the timer.
»
The show can be terminated at any time
by pressing the »end« button
12
.
The »memo« button 21 can be activated as
in the manual mode.
Making corrections during a test run
It is often necessary to change the dissolve or
screen time of a slide.
»
To do this, press the »stop/go« button
16
during the test run while the corresponding
slide is being shown.
»
If the timer-correction button
37
or
one of the three dissolve buttons
14
is then
pressed, this will change the previously recor-
ded screen time of the slide being shown or
the dissolve duration from this to the next
slide.
»
If, however, the dissolve time being
watched is to be corrected, first press the red
reverse button before making the correction.
Additional reverse commands are, however,
impossible during test runs.
»
To resume the show, press the green for-
ward button
19
or the »stop/go« button
16
.
PROGRAMMING
37
Basics