Manual
Double Sheet Detector R1000 series UDK20
Start-up
B0048991 / Rev. 1.3
86
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Program parameter 7:
Zero adjust
Fig. 40: Status of Zero adjust
Zero adjust is initiated with the ENTER key. If no zero adjust was executed or if it has to be
repeated, the menu option “on“ has to be selected.
Then the following message appears (with version 2PW only):
•
Separate:
All connected sensors must be zero adjusted individually, each sensor is
addressed individually for yes or no.
•
Common:
All sensors are zero adjusted at the same time. In any case the zero adjust
continues with the following message, requesting to remove the sheet:
Fig. 41: Removing sheet for zero adjust
After having the sheet removed, press the ENTER key. Then the following message appears
during the zero adjust:
Fig. 42: Display during zero adjust
Note
Fault messages are described in the chapter 9. “Fault messages“.
When the zero adjust is completed, the following message appears:
Fig. 43: Zero adjust successfully completed
The zero adjust is now completed.
program par. 7
zero adj.: done
program par. 7
please wait
program par. 7
zero adj.: off
program par. 7
remove sheet!