Roland Music Atelier AT-45, Owner'S Manual

Page: 19 / 228

19
Before You Start Playing
Restoring All the Factory
Default Settings
You can restore all of the settings stored in the AT-45 to what
they were when the instrument shipped from the factory.
This function is called “Factory Reset.”
1.
Make sure there is no floppy disk in the disk
drive before carrying out the procedure.
2.
Touch <System> on the Main screen.
The System screen appears.
fig.00-37.eps
3.
In the System screen, touch <Utility> to open the
Utility screen.
fig.00-38.eps
4.
In the Utility screen, touch <Factory Reset>.
fig.00-39.eps
To restore all settings other than the User memory (p. 52) to
their original factory settings, touch <Panel Reset>.
The confirmation message appears on screen.
fig.00-40.eps
If you touch <Cancel>, the Factory Reset will not be
performed, and you will return to the System screen.
5.
When you touch <OK>, the Factory Reset
operation will begin, and the settings will return
to the factory-set condition.
NOTE
Never switch off the power while this operation is in
progress!
fig.00-40.eps
NOTE
Loading factory default settings will erase any Registrations
currently in the memory of the AT-45. To save the
registrations you are currently using, refer to “Saving
Registration Sets to a Floppy Disk” (p. 88).
NOTE
To reset only the User memory (p. 52) to its original factory
settings, refer to p. 68.
AT-45_e.book 19 ページ ２００５年２月２１日 月曜日 午後５時４３分