80
Chapter 5 - Menus and Keys
5-2 Description of Menus
Setting
range
D I S A B L E /
ENABLE
mm/INCH
—
—
—
—
Default
value
DISABLE
mm
—
—
—
—
Function
This specifies whether the automatic cleaning during printing is en-
abled or disabled.
When set to [ENABLE], automatic cleaning is performed during print-
ing, and prevents drop-out and ink drips. Because automatic clean-
ing is performed during printing, printing may take more time. The
lower the temperature of the work area, the greater is the number of
times that automatic cleaning is performed.
Also, because printing is interrupted temporarily during automatic
cleaning, horizontal stripes may occur in the printing.
This selects millimeters or inches as the unit of measurement for the
width displayed on the top menu after setting up the media. When
inch display is used, values are displayed to the first digit to the right
of the decimal point.
This prints the current status of settings and other system informa-
tion.
This prompts you to replace the separating knife.
This returns all menu settings to their original values when shipped
from the factory.
For more about the factory defaults for the various settings, see the
"Default value" entry for each menu setting in this section.
This shows the amount of ink left after each of the ink cartridges has
been installed.
The fewer the markers (" "), the less ink is left.
* If a partially used ink cartridge is removed and reinstalled, or if a
partially used ink cartridge is installed, the cartridge is taken to be
unused, and the displayed amount of remaining ink is not true.
For more information, see "3-2 Checking the Remaining Ink Level."
Top menu
PERIODIC CL.
UNIT
SYSTEM REPORT
REPLACE KNIFE
FACTORY DE-
FAULT
INK
REMAINING
Submenu
—
—
—
—
—
—
