Chapter 4 Appendix
Symptom
Points to check
Action
Refer to
There is no problem with
the file in the preview
display, but the job is
printed in an undesired
shape
Are the computer's
display settings
suitable for the
machine?
Depending on the computer’s
display settings, file output
may stop, causing printing to
fail.
Configure the computer's
display settings to suit the
machine.
P.11
Are you using a
secondary monitor with
the computer?
Using multiple monitors can
sometimes affect printing.
Do not connect a secondary
monitor to the computer.
—
Did you use another
program or switch
to another program
during printing?
Using multiple programs,
switching between programs
(tasks) can sometimes affect
printing.
Do not use (launch) other
programs at the same time as
Quick Denta.
—
The job does not attach
to the platform (it remains
in the liquid material vat)
Is the liquid material
vat dirty or cloudy?
If the bottom of the liquid
material vat is cloudy, set the
non-cloudy part toward the
back of the machine.
If the liquid material vat is
dirty, wash it.
Alternately, replace the liquid
material vat with a new one.
P.53
P.54
Is the surface of the
printing platform dirty?
Is it scratched or
deformed?
If the printing platform is dirty,
wash it.
If it is scratched or deformed,
replace it with a new printing
platform.
P.36
Has the initial height
of the printing platform
been adjusted?
Adjust the initial printing height
to the optimum height.
P.20
Is there resin that
failed to print stuck to
the surface of the liquid
material vat?
Use the tweezers or some
other tool to remove any resin
that has become stuck to the
surface of the liquid material
vat.
—
Troubleshooting
58
Summary of Contents for DWP-80S
Page 78: ...R1 161121 FA01081 ...