Chapter 4 Appendix
Troubleshooting
The Machine Doesn't Work
Symptom
Points to check
Action
Refer to
The machine does not
output the print file
Is the machine turned
on?
Turn on the machine.
P.10
Has the connector
cable come loose?
Connect the cable.
Setup Guide
Does the computer
have enough disk
space?
The computer was unable to
obtain the disk space required
to output the file.
Increase the amount of
free disk space by deleting
unnecessary files, etc.
—
Printing Fails
Symptom
Points to check
Action
Refer to
Part of the job on the
liquid material vat side is
missing
Is the liquid material
vat dirty or cloudy?
If the bottom of the liquid
material vat is cloudy, set the
non-cloudy part toward the
back of the machine.
If the liquid material vat is dirty,
wash it.
Alternately, replace the liquid
material vat with a new one.
P.53
P.54
Is there enough resin
in the liquid material
vat?
Check the “Estimated job
volume” displayed in Quick
Denta before printing and make
sure there is enough resin in
the liquid material vat.
Printing will also not be possible
if there is not enough resin in
the printing part of the liquid
material vat (toward the rear of
the liquid material vat). Make
sure there is enough resin in
the liquid material vat so that
the rear of the vat does not
become empty while printing.
P.28
Is there a problem
with the angle of the
machine?
It is necessary to position the
machine on an angle so that
the remaining resin collects in
the printing part (the back of
the liquid material vat) even as
the amount of resin decreases
during printing. For information
on how to adjust the machine
tilt, refer to the “Setup Guide.”
Setup Guide
56
Summary of Contents for DWP-80S
Page 78: ...R1 161121 FA01081 ...