Chapter 4 Appendix
Symptom
Points to check
Action
Refer to
Part of the job on the
platform side is missing
Are there supports
attached around the
missing part?
Increase the number of
supports.
P.46
Part of the job is missing
along the vertical edge of
the work area
Is the object contained
within the work area?
Areas of the object that extend
outside the work area will not
be printed. Check that the file
is contained within the work
area.
P.25
Quick Denta
Help
The job drops into the
liquid material vat
Is the liquid material
vat dirty or cloudy?
If the bottom of the liquid
material vat is cloudy, set the
non-cloudy part toward the
back of the machine.
If the liquid material vat is
dirty, wash it.
Alternately, replace the liquid
material vat with a new one.
P.53
Has the initial height
of the printing platform
been adjusted?
Adjust the initial printing height
to the optimum height.
P.20
Is the object's center
of gravity heavily
skewed?
Change the shape of the
object so that the center of
gravity is in the center of the
job.
—
Increase the number of
supports.
P.46
Quick Denta
Help
Is the density of the
supports low?
Increase the number of
supports.
P.41
Quick Denta
Help
Troubleshooting
57
Summary of Contents for DWP-80S
Page 78: ...R1 161121 FA01081 ...
