30
Event
E A4
Temperature increase too low on full power
This error message refers to a kiln problem .
Possible causes:
• Defective mains fuse / phase, broken heating elements
• Heating elements too old (high temperatures)
• Short circuit on thermocouple or compensating wire
• Defective contactor (often occurs during firing process)
Event
E A5
Kiln does not follow programmed temperature increase
Other than Event A4, values for temperature increase have been set too high and
the kiln cannot follow the programmed values . This message is displayed only if
enabled in the configuration .
Event
E A8
Ramp has been continued automatically
If the kiln cannot follow the temperature increase, the ramp will be intermitted . If the
controller finds the kiln unable to catch up with the temperature the firing will continue
and this message will be displayed for one minute .
Event
E A9
SKIP ramp interrupted
If the controller failed to reach the end temperature in an uncontrolled ramp it will
continue with the next segment - see section “Uncontrolled ramps (SKIP)“ . This
message is informative and is displayed for one minute .
Event
E B3
Firing process interrupted after power failure
After re-establishing power supply, the firing process has been interrupted because,
for example, kiln temperature has dropped too much . A digit shown after the comma
will provide further information concerning the cause (e .g . B 3 .4 = temperature
dropped too much) .
If this message is displayed immediately after the controller has been turned on, you
may ignore it . This indicates that the controller was turned off while the firing process
and program were still operational . Simply continue working by entering a program .
