20
Mount the TC 504 controller
Mounting the controller on the wall
Choose a safe and easily accessible position on a wall next to the kiln . First screw
the two knurled screws into the holes indicated on the back of the control unit . They
will be used later to fasten the controller in the fixing device .
Mount the holding bar of the TC 504 control unit using the 3 dowels and 3 screws,
with one fixing hole pointing upwards and the other
two pointing downwards .
Make sure that the transparent protective foil is cor-
rectly aligned!
The control unit can now be plugged into the fixing
device from above . You might have to loosen the
knurled screws on the controller .
Mounting the controller on the KE controller panel
Place the frontloader panel in a position that will allow the star-shaped knob to be
turned until it locks into the position indicated . When the panel is fixed, you can start
mounting the controller on the panel .
Mount the holding bar of the TC 504 control unit using the 3 screws, nuts and
washers, with one fixing hole pointing upwards and the other two pointing down-
wards .
Make sure that the transparent protective foil is correctly aligned!
First screw the two knurled screws into the holes indicated on the back of the
control unit .
The control unit can now be plugged into the fixing device from above . You might
have to loosen the knurled screws on the controller .
