Preparing for use
R&S
®
ZND
23
Getting Started 1316.2407.02 ─ 62
3.11.5
Connecting a LAN cable
A LAN cable can be connected to the LAN connector on the rear panel of the analyzer.
To establish a LAN connection, proceed as follows:
1. Refer to
Chapter 7.2.1, "Assigning an IP address"
2. Connect a CAT6 or CAT7 LAN cable to the LAN port.
The LAN port of the analyzer is an auto-crossover Ethernet port. You can connect it to
a network, but you can also set up a direct connection to a computer or another instru-
ment. For both connection types, you can use either crossover or straight through
(patch) cables.
The IP address information is displayed in the SYSTEM – [SETUP] > "Remote Set-
tings" softtool tab.
Connecting external accessories
