66
Shock Eyelet Service - Standard Eyelet
S h o c k E y e l e t S e r v i c e - S t a n d a r d E y e l e t
P a r t s , T o o l s , a n d S u p p l i e s
Safety and Protection Supplies
• Apron
• Clean, lint-free shop towels
• Nitrile gloves
• Safety glasses
RockShox Tools
• RockShox 1/2" x 1/2" Rear Shock Bushing Tool
Common Tools
• Open end wrench 13 mm (x2) or adjustable open end wrench (2)
• Bench vise with aluminum soft jaws
M o u n t i n g H a r d w a r e I n s t a l l a t i o n - S t a n d a r d E y e l e t
Some mounting hardware is easily installed using only your fingers. Press the bushing pin into the standard shock eyelet bushing until the pin
protrudes from both sides of the eyelet an equal amount. Next, press an end spacer, large outer diameter side first, onto each end of the bushing pin.
If this works, you have completed mounting hardware and bushing service.
If you are unable to install your standard eyelet mounting hardware using your fingers, use the RockShox Rear Shock 1/2" x 1/2" Bushing Tool.
Thread the small end of the push pin (A) onto the threaded rod (B) until
Thread the small end of the push pin (A) onto the threaded rod (B) until
the rod protrudes from the hex-shaped end of the push pin.
the rod protrudes from the hex-shaped end of the push pin.
Insert the pin into the eyelet bushing.
Insert the pin into the eyelet bushing.
Insert the threaded rod (A) through the bushing pin, then through the
Insert the threaded rod (A) through the bushing pin, then through the
shaft eyelet so that the bushing pin (B) is positioned between the push
shaft eyelet so that the bushing pin (B) is positioned between the push
pin (C) and the eyelet.
pin (C) and the eyelet.
1
RockShox 1/2" x 1/2" Rear Shock Bushing Tool
A
B
2
3
RockShox 1/2" x 1/2" Rear Shock Bushing Tool
B
C
A
