23
Bearing Installation - Shaft Eyelet
Loosen the vise, and align the bearing press tool centered on the
Loosen the vise, and align the bearing press tool centered on the
bearing, then slowly tighten the vise. Check and confirm the bearing
bearing, then slowly tighten the vise. Check and confirm the bearing
press tool is centered and is not overlapping the bearing edge.
press tool is centered and is not overlapping the bearing edge.
Press the bearing into the bearing bore until it stops.
Press the bearing into the bearing bore until it stops.
Remove the shock and bearing press tool from the vise.
Remove the shock and bearing press tool from the vise.
NOTICE
Do not overtighten the bearing. Overtightening can damage the
bearing and cause it to malfunction.
To prevent damage to the bearing, make sure that the bearing press
tool contacts both the inner and outer races of the bearing.
2
22 mm (OD) x 10 mm (ID)
bearing press tool
