14
Mounting Hardware Removal
If the bushing pin does not remove easily, reinsert the threaded rod
If the bushing pin does not remove easily, reinsert the threaded rod
and push pin through the eyelet shaft.
and push pin through the eyelet shaft.
Thread the large, open end of the catcher along the rod until it rests
Thread the large, open end of the catcher along the rod until it rests
against the shaft end spacer.
against the shaft end spacer.
Use a 13 mm wrench to thread the push pin along the rod until it
Use a 13 mm wrench to thread the push pin along the rod until it
pushes the pin completely out of the eyelet and stops against the
pushes the pin completely out of the eyelet and stops against the
eyelet.
eyelet.
Unthread the catcher from the threaded rod.
Unthread the catcher from the threaded rod.
Remove the end spacer and bushing pin from the tool. Remove the
Remove the end spacer and bushing pin from the tool. Remove the
spacer from the bushing pin.
spacer from the bushing pin.
Damper Body with Standard Eyelet:
Damper Body with Standard Eyelet:
Repeat steps 2-4 for the damper
Repeat steps 2-4 for the damper
eyelet.
eyelet.
Set the mounting hardware aside until you have finished servicing the
Set the mounting hardware aside until you have finished servicing the
shock.
shock.
4
13 mm
13 mm
5
