67
Mounting Hardware Installation - Standard Eyelet
Thread the large, open end of the catcher (A) onto the threaded rod (B)
Thread the large, open end of the catcher (A) onto the threaded rod (B)
until the catcher rests on the eyelet.
until the catcher rests on the eyelet.
Hold the catcher secure with a 13 mm wrench.
Hold the catcher secure with a 13 mm wrench.
Use a second 13 mm wrench to thread the push pin along the rod until
Use a second 13 mm wrench to thread the push pin along the rod until
it pushes the bushing pin into the shock eyelet bushing.
it pushes the bushing pin into the shock eyelet bushing.
Use one spacer to check the pin position. The pin should be centered
Use one spacer to check the pin position. The pin should be centered
in the eyelet.
in the eyelet.
Continue to thread the push pin until the bushing pin protrudes from
Continue to thread the push pin until the bushing pin protrudes from
both sides of the eyelet an equal amount.
both sides of the eyelet an equal amount.
You may need to unthread the catcher slightly to check the bushing pin
You may need to unthread the catcher slightly to check the bushing pin
spacing.
spacing.
Remove the bushing tool.
Remove the bushing tool.
4
RockShox 1/2" x 1/2" Rear Shock Bushing Tool
A
B
5
13 mm - clockwise
13 mm
