13
Mounting Hardware Removal
Thread the small end of the push pin (A) onto the threaded rod (B) until
Thread the small end of the push pin (A) onto the threaded rod (B) until
the rod protrudes from the hex-shaped end of the push pin.
the rod protrudes from the hex-shaped end of the push pin.
Insert the threaded rod (A) through the shaft eyelet until the push pin
Insert the threaded rod (A) through the shaft eyelet until the push pin
(B) rests against the bushing pin.
(B) rests against the bushing pin.
Thread the large, open end of the catcher (C) along the rod until it rests
Thread the large, open end of the catcher (C) along the rod until it rests
on the end spacer.
on the end spacer.
Hold the pin catcher secure with a 13 mm open end or adjustable
Hold the pin catcher secure with a 13 mm open end or adjustable
wrench.
wrench.
NOTICE
Do not scratch the air can as you turn the wrench.
Use a second 13 mm wrench to thread the push pin into the bushing
Use a second 13 mm wrench to thread the push pin into the bushing
pin and eyelet until it stops against the end spacer, or when spacer is
pin and eyelet until it stops against the end spacer, or when spacer is
free from the pin.
free from the pin.
Unthread the catcher and push pin from the threaded rod to remove
Unthread the catcher and push pin from the threaded rod to remove
the end spacer and the bushing pivot pin.
the end spacer and the bushing pivot pin.
1
RockShox 1/2" x 1/2" Rear Shock Bushing Tool
A
B
2
A
B
C
3
13 mm
13 mm
