14.3
Removing The Main Burner
(a) Remove the control assembly as previously described in
Section 14.2.
(b) Remove the glass door seal by unscrewing the ten wing
nuts. Put the glass door in a safe place to avoid
damage.
(c) Remove the coal bed and place in a safe place to avoid
damage.
(d) Unscrew the wing nut on the left side of the combustion
chamber.
(e) Remove the main injectors noting the correct installation
and place in a safe place (Fig 19.).
(f) Using a spanner unscrew the six screws holding the
burner support plate in position (Fig 19.).
(g) Remove the burner by sliding it towards the right (1) and
then lift the left end of the burner upwards (2),
(see Fig 18. The burner can now be withdrawn through
the front opening.
(h) Refitting is the reverse procedure of removal.
14.4
Removing The Main Burner Injectors
(Fig 19)
(a) Remove the controls assembly as previously described
in Section 14.2.
(b) Unscrew the main burner injectors on at a time. If both
injectors are removed at the same time the main burner
will drop down out of position making injector refitting
difficult.
(c) Refitting is the reverse procedure of removal.
16
Fig 19.
Main Injectors
Remove these
6 screws
Fig 18.
(2)
(1)
Fig 17.
Mounting
screws
