3
Fig. 1
- Glue the fin to the fuselage, taking care to set it exactly at
right-angles to the tailplane (see Fig. 2).
Fig. 3
- Referring to Fig. 3, glue the horizontal strake to the fin,
keeping it exactly central. The swept face of the strake
faces aft.
Fig. 4
- Glue the two dummy exhausts in the recesses on the un-
derside of the fuselage (see also Fig. 5).
Fig. 6
- Position the airborne components such as the flight battery
(Article No.: 6603 or 6605) and receiver as shown in Fig.
6; this will ensure that the model balances at the stated
Centre of Gravity.
Fig. 7
- Glue the fuselage extension in the appropriate slot in the
rear of the canopy (see also Fig. 8).
Fig. 9
- The Centre of Gravity is located 40 mm aft of the leading
edge at the wing root.
Fig. 10 (control surface travels)
- The control surface travels are measured at the inboard
end of the control surface.
- The stated control travels are just a guide for the first few
flights. Every pilot has to make fine adjustments to suit his
personal flying style.
Expo settings
Elevator -40%; aileron -60%
- The Expo settings should also be adjusted to suit the pilot‘s
preference.
Building and Operating Instructions - Grob G 120TP Nano-Racer
No. 2598
10
5 mm
5 mm
Elevator
Aileron
4 mm
4 mm
