5. How to Set Display Mode
5-1. Entering the display mode
- 29 -
Display mode overview
Item
LCD display
Details
Peak display
Displays the maximum concentration
detected during the period from power-
on to the point of checking.
* To clear the peak display, hold down
the RESET button until "CLEAR -
RELEASE" is displayed.
Concentration displayed
gas reading setting
By changing the setting to the pre-
registered gas in the gas detector, the
converted concentration from the
detection target gas (CH4) will be
displayed.
(P. 31)
Alarm setpoint display
Displays the alarm setpoint of the gas
detector.
* Press the ENTER button while the
alarm setpoint is displayed to perform
alarm test for the setting.
(P. 34)
Pump suction volume
setting
Changes (in small measure) the pump
suction volume.
(P. 36)
* L: Low (suction volume <low>)
H: High (suction volume <high>)
Log data display
Displays the data recorded by the snap
logger.
(P. 38)
