Installation
Installation
Instructions
Instructions
& R e c o m m e n d e d
P r o c e d u r e s
LASER DEFUSER EX
(FRONT LICENSE PLATE MOUNT WITH FRAME)
1. Remove the mounting bolts and any existing frame or cover from the license plate. Remove license plate.
2. Position the Laser Defuser EX around the existing front license plate and mount it against the factory license
plate bracket. Use the existing mounting bolts or K40 supplied nylon bolts to secure the Laser Defuser EX
frame and license plate to the bracket.
The
Defuser EX
system is ideal for small to mid-size vehicles, and comes packaged in an ordinary looking
license plate frame. It may be installed with or without the license plate frame as needed.
The
Defuser EX2
system is recommended for larger size vehicles, or when a front license plate mount
is not used on the vehicle. The system includes two separate Defuser modules with no license plate frames.
On vehicles that have only one set of bracket mounting holes, it is recommended that the Laser
Defuser EX and the license plate be bolted together to eliminate any vibration.
DIAGRAM A3
3. For proper performance, the Defuser EX must be mounted completely level. A unit which is positioned up,
down, or to the side by as little as 1° can reduce jamming effectiveness by as much as several hundred feet
(see diagram A1).
To assure the Defuser EX is properly leveled, insert the rod on the K40 supplied level into the leveling assem-
bly hole located on the top of the Defuser EX frame (see diagram A2). Be sure that the vehicle is on a level
surface before checking installation.
NOTE:
DIAGRAM A1
DIAGRAM A2
Use the K40 supplied nylon nuts
and bolts to correct either up or
down as needed (see diagram A3).
4. Route the black cable into the engine
compartment either through the grill
or under the bumper. Connect wires
per the separate enclosed block
diagram sheet.
On some vehicles, it may be necessary to adjust or reposition the factory license plate bracket to
achieve the desired level installation.
NOTE:
LASER
DEFUSER
FACTORY
MOUNTING
LOCATION
MOUNTING NUTS
JAMMING BEAM
LASER
DEFUSER EX
Enlarged
View
Enlarged
View
Enlarged
View
JAMMING BEAM
LASER
DEFUSER EX
LASER
DEFUSER EX
JAMMING BEAM
CORRECT
NO
NO
