Rigol MSO5000 Series, User Manual

Page: 122 / 358

RIGOL
Chapter 5 To Trigger the Oscilloscope
5-40 MSO5000 User's Guide
Baud Rate:
Press More

Baud to set the baud rate. Three setting methods are available for
baud rate:

Press Baud , then set the user-defined baud rate with the displayed numeric
keypad.

Press Baud , then rotate the multifunction knob to select the preset baud
rate from the available options. The available baud rates include 10 kb/s, 20 kb/s,
33.3 kb/s, 50 kb/s, 62.5 kb/s, 83.3 kb/s, and etc.

Press Baud , then rotate the multifunction knob to adjust the baud rate at a
small step of 0.1 kb/s.
Sample Position:
Sample position is a point within a bit’s time. The oscilloscope samples the bit level at
this point. The sample position is represented by the proportion of "the time from the
start of the bit to the sample position" to the "bit time", as shown in the figure below.
Figure 5-18 Sample Position
Press More

Sample Position , then rotate the multifunction knob or use the
pop-up numeric keypad to set the sample position. The settable range is from 10%
to 90%.
Trigger Mode:
In the trigger control area (Trigger) on the front panel, press Mode to quickly switch
the current trigger mode. For details, refer to descriptions in "Trigger Mode" .
Trigger Parameter Setting:
Set the trigger parameter (noise rejection) under this trigger type. For details, refer
to descriptions in "Noise Rejection" .
Trigger LEVEL/Threshold Level:
Rotate the Trigger LEVEL knob to adjust the trigger level/threshold level. Refer
to "Trigger LEVEL/Threshold Level" . The current trigger level/threshold level
value is displayed at the upper-right corner of the screen.
One Bit
60%
70%
80%
www.
GlobalTestSupply
.com
Find Quality Products Online at: sales@GlobalTestSupply.com