99
10-3. Printer
Phenomenon
Check point
Cause and action
The printer connected to
the station does not turn
on when the printer power
switch is flipped on.
Is the printer correctly
connected to the station?
Correct the connection.
(See”3
-4-2 Automatic Charging
of the Printer”.)
Is the station in a
power-off state?
The printer will not operate if
the station is not turned on.
Turn on the station.
The battery pack is set in
the printer, but the power
lamp does not light when
the power switch is set to
on.
Is the battery pack in the
correct orientation?
Check that the battery pack is
correctly installed. (See“3
-2-2
Installing and Removing the
Printer Battery Pack”.)
Is the battery lamp
flashing or lit in yellow?
Recharge the battery pack.(See
“3
-4 Charging the Battery
pack”.)
The printer power lamp
flashes.
Is the battery lamp
flashing or lit in yellow?
Recharge the battery pack.(See
“3
-4 Charging the Battery
pack”.)
Is the print roll set
correctly? (Beeps if not
correctly set.)
Set the print roll correctly.
(See “9
-2 Replacing the Print
Roll”.)
Is the paper holder cover
open?
(Beeps if not correctly set.)
Close the paper holder cover.
The buzzer beeps
repeatedly.
Is the print roll set
correctly?
Set the print roll correctly.
(See “9
-2 Replacing the Print
Roll”.)
Is there a problem with
the RS-232C connection to
the external device or a
problem with the external
device?
Check that the communication
cable is properly connected on
both ends. Carefully read the
instructions of the external
device.
Nothing prints.
Are you using the
designated print roll?
Use the designated print roll.
Is the paper holder cover
open?
Close the paper holder cover.
Is the paper roll inserted
upside down?
Set the print roll correctly.
(See “9
-2 Replacing the Print
Roll”.)
