56
CONFIGURATION OF THE MAIN BLOCK DIAGRAMS
− Zone sensor (S2)
This is required to adjust and control an additional direct zone managed by the “Depending” thermal module in
combination with the zone circulator (P2).
The zone sensor is used to adjust and control an additional mixed zone in combination with the zone circulator (P2) and
the mixer valve (V2).
The zone sensor (S2), circulator (P2) and the mixer valve (if present) (V2) must be connected to the "Depending" thermal
module, which communicates via bus with the "Managing" thermal module.
SC
PC
PC
SE
EAF
PI
P2
V2
S2
SS
MANAGING
DEPENDING
P
PC
DEPENDING
M
− Zone sensor (S3)
This is required to adjust and control an additional direct zone in combination with an electronic device for zone
management (ZM) and the zone circulator (P3).
The zone sensor is used to adjust and control an additional mixed direct zone in combination with an electronic device for
zone management (ZM), the zone (P3) circulator and the mixer valve (V3).
The zone sensor (S3), the circulator (P3) and the mixer valve (if present) (V3) must be connected to the electronic device for
zone management (ZM), which communicates via Bus with the "Managing" thermal module.
SC
PC
PC
SE
EAF
PI
P2
V2
S2
SS
MANAGING
DEPENDING
P
PC
DEPENDING
P3
V3
S3
ZM
M
M
To make the electrical connections, refer to the wiring diagrams of the selected system.
For the Bus connection mode, refer to the section "System management".
Summary of Contents for Condexa PRO 100
Page 32: ...32 INSTALLATION 7 Position the GAS manifold 8 Secure the GAS manifold to the frame 7 7 8...
Page 33: ...33 INSTALLATION 9 Position the manifold closing plugs from the required side 9 22mm 51mm...
Page 36: ...36 INSTALLATION 7 Position the GAS manifold 8 Secure the GAS manifold to the frame 8 8 7...
Page 37: ...37 INSTALLATION 9 Position the manifold closing plugs from the required side 9 22mm 51mm...
