75
COMMISSIONING AND MAINTENANCE
6
COMMISSIONING AND MAINTENANCE
6.1
Repositioning the front panels
Before putting the appliance into service, make sure that all the
thermal modules have been reassembled with their own front
panel:
1
Insert the panel into the seats on the points (B).
2
Push it forwards until contact is made and then secure
using the designated screw (A).
B
B
A
1
2
6.2
Putting the system into service
The first time the
Condexa PRO
is used, the following checks and
operations must be carried out:
− Check that the gas cock and heating water cock are open
− Check that the pressure of the hydraulic circuit when cold
is always greater than 1 bar and less than the maximum
limit permitted for the system
− Set the main switch of the system to ON and the main
switch of all the thermal modules to (I), starting with the
Managing thermal module.
Summary of Contents for Condexa PRO 100
Page 32: ...32 INSTALLATION 7 Position the GAS manifold 8 Secure the GAS manifold to the frame 7 7 8...
Page 33: ...33 INSTALLATION 9 Position the manifold closing plugs from the required side 9 22mm 51mm...
Page 36: ...36 INSTALLATION 7 Position the GAS manifold 8 Secure the GAS manifold to the frame 8 8 7...
Page 37: ...37 INSTALLATION 9 Position the manifold closing plugs from the required side 9 22mm 51mm...
