Riello 20155654, Installation, Use And Maintenance Instructions

Page: 39 / 84

37 20155699 GB
Operating control and display
7.4.2 Recall fault history
Display burner faults
Use cursor keys to select menu and press ENTER
to confirm.
The display shows Fault history selection menu.
1 Burner fault pictogram [selected]
Use keys to select menu and press ENTER
to confirm.
The display shows Fault history menu.
1 Error code-display pictogram
2 Fault code (Last 10 faults are stored, no. 01 is the latest
fault)
3 Diagnostic code 1
4 Diagnostic code 2
5 Number of operating hours when fault has occurred
NOTE:
information concerning fault and diagnostic codes you may
find in the list of fault codes.
For fault analysis a fault code and diagnostic code D1 or D2
is required.
Fault unlock
Display faults unlocking

A fault is pending and the ERROR key is flashing.

Press ENTER-Taste. BT300 is not locked anymore.
Changing from fault unlock to main menu

A fault is pending and the ERROR key is flashing

Press BACK key.
ENTER key isn't flashing any more.
The display returns to main menu.
An error number is flashing in the display on top left.
UI300 can be used as usual.
Back to fault unlock

An error number is flashing in the display on top left.

Use BACK key to switch back to main menu.

Press arrow-key left.
ENTER key is flashing again.
BT300 can be unlocked.
NOTE:
If the ENER key has a permanent red light, there is gas short-
age.
A countdown to the next start is running.
This countdown can be interrupted by the ENTER key.
7.4.3 Software version
Display software version
Use cursor keys to select menu and press ENTER
to confirm.
The display shows the Software version menu.
1 Software version pictogram
2 UI300 software version (User Interface)
3 BT300 software version (BurnerTronic)
Fig. 39
S9355
Fig. 40
S9357
Fig. 41
S9359