Ricoh SP 4510 DN, User Manual

Page: 80 / 144

Message Cause Solution
"Standard Tray is full. Remove the
paper." The standard tray is full. Remove the paper.
"Supply order has failed." The automatic supply order
failed. The message indicates the
printer tried to order the
supplies.
"This NetBIOS name is already in use.
(108/208)" The NetBIOS name specified
for the printer is already used
by another device on the
network. Contact your network
administrator.
"The same IPv4 Address already
exists.(102/202)" The IPv4 address specified
for the printer is already used
by another device on the
network. Contact your network
administrator.
"The selected job has already been
printed or deleted." This message might appear if
you print or delete a job from
Web Image Monitor. Press Exit on the message
screen.
"USB has a problem. Please call
service." The printer has detected a
USB board failure. Turn the printer off, and then
turn it on again. If the
problem persists, contact
your sales or service
representative.
"Values set for IPv6/Gateway
addresses are invalid.(110/210)" The IPv6 address or gateway
address is invalid. Check the network settings.
"Waste Toner almost full" The print cartridge must be
replaced when the life of the
waste toner is ending. Prepare a new print
cartridge.
"Waste Toner full" The waste toner is full. For details, see "Replacing
the Print Cartridge",
Operating Instructions.
"WPA Auth. incomplete.(211)" WPA authentication could
not be completed. Contact your network
administrator.
3. Troubleshooting
78