Ricoh M022, Service Manual

Page: 785 / 1152

001
Feed Condition *ENG [0 or 2 / 0 / 1]
Selects the paper feed timing.
0: Productivity priority, 1: Fusing quality priory
Note:
When the print paper size changes from a small to a large size, you can stop the print job
in order to ensure that the fusing temperature is high enough, and then resume it when the
proper temperature has been reached.
This mode is used on machines in which the fusing ability is low, for example when there is
one fusing lamp. And it is mainly used on A3 MFPs which change repeatedly between A3
and A4 size. However, it is not used on machines in which there are two heating lamps, such
as A4 MFPs which almost never change between A4 and A5.
1121 [Maximum Duty Switch] DFU
001
Control Method Switch *ENG [0 or 1 / 1 / 1]
Selects the power control method for the fusing unit.
0: Fixed control, 1: Power control
The machine is used over the rated voltage of PSU. For example, 1700w can be used at the
machine of 1500w. When the fusing ability is too low early morning, or the electrical power
environment is not stable, this switch can be used. However, there is a risk of over-voltage
when using this SP, since it is not used under normal conditions.
1159 [Fusing Jam Detection]
001
SC Display *ENG [0 or 1 / 0 / 1]
Enables or disables the fusing consecutive jam (three times) SC detection.
0: No detection, 1: Detection
1201 [CPM Down Setting] DFU
001 Low: Down Temp. *ENG [-50 to 0 / -10/ 1 deg/step]
002 Low: Up Temp. *ENG [-50 to 0 / -7/ 1 deg/step]
003 Low: 1st CPM *ENG [10 to 100 / 80 / 5 %]
004 Low: 2nd CPM *ENG [10 to 100 / 65 / 5 %]
005 Low: 3rd CPM *ENG [10 to 100 / 50 / 5 %]
System SP-xxx
39
3
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA