Ricoh M022, Service Manual

Page: 778 / 1152

002
Pre-Idling Time *ENG [0 to 120 / 0 / 1 sec/step]
Specifies the fusing rotation time before executing SP1109-001.
003
Stop Time * ENG [5 to 30 / 20 / 1 sec/step]
Specifies the time for measuring the nip.
1112 [Envir. Correct: Fusing]
001
Temp.: Threshold: Low *ENG [10 to 23 / 17 / 1 deg/step]
Specifies the threshold temperature for low temperature condition.
002
Temp.: Threshold: High *ENG [24 to 40 / 30 / 1 deg/step]
Specifies the threshold temperature for high temperature condition.
003
Low Temp. Correction *ENG [0 to 15 / 5 / 1 deg/step]
Specifies the temperature correction for the heating roller. When the low temperature
condition (specified with SP1112-001) is detected, the value of this SP is added to the heating
roller temperature.
004
High Temp. Correction *ENG [0 to 15 / 3 / 1 deg/step]
Specifies the temperature correction for the heating roller. When the high temperature
condition (specified with SP1112-002) is detected, the value of this SP is subtracted from
the heating roller temperature.
005 Offset Temp:Low *ENG [0 to 15 / 5 / 0.1 deg/step]
006 Offset Temp:High *ENG [0 to 15 / 3 / 0.1 deg/step]
1113 [Stand-by Mode Setting]
001 Wait Time AF Ready *ENG [0 to 60 / 30 / 1 sec/step]
003
Wait Time AF Recovery *ENG [0 to 60 / 10 / 1 sec/step]
Specifies the time for keeping the target temperature without any jobs after recovery
(SP1105-083).
004
Wait Time AF Job *ENG [0 to 60 / 10 / 1 sec/step]
Specifies the time for keeping the target temperature without any jobs after a last job.
3. Appendix: SP Mode Tables
32
3
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA