Ricoh M022, Service Manual

Page: 184 / 1152

8. White pulley [A] ( x 1)
9. Follow steps 6 through 8 in the "Front Scanner Wire" Section. You can remove the rear scanner wire
with the same manner for replacing the front scanner wire.
Reinstalling the Rear Scanner Wire
1. Position the center ball [A] in the middle of the forked holder.
2. Pass the left end (with the ball) [B] through the drive pulley notch. Pass the right end (with the ring) [C]
through the drive pulley hole.
3. Wind the left end [B] clockwise (shown from the machine's front). Wind the right end [C]
counterclockwise.
• The two blue marks [D] come together when you do this. Attach the wire to the pulley with tape.
This lets you easily handle the assembly at the time of installation.
4. Install the drive pulley on the shaft.
4. Replacement and Adjustment
182
4
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA