Ricoh M022, Service Manual

Page: 1013 / 1152

163
Access Point
This is the number of the dial-up access point for RCG-M. If no setting is done for this SP
code, then a preset value (determined by the country selected) is used.
Default: 0
Allowed: Up to 16 alphanumeric characters
164
Line Connecting
This SP sets the connection conditions for the customer. This setting dedicates the line to
RCG-M only, or sets the line for sharing between RCG-M and a fax unit.
[0 to 1 / 0 / 1 /step]
0: Sharing Fax
1: No Sharing Fax
• If this setting is changed, the copier must be cycled off and on.
• SP5816 187 determines whether the off-hook button can be used to interrupt a RCG-
M transmission in progress to open the line for fax transaction.
173 Modem Serial Number
This SP displays the serial number registered for the RCG
-M.
174
Retransmission Limit
Normally, it is best to allow unlimited time for certification and ID2 update requests, and
for the notification that the certification has been completed. However, RCG -M generates
charges based on transmission time for the customer, so a limit is placed upon the time
allowed for these transactions.
If these transactions cannot be completed within the allowed time, do this SP to cancel the
time restriction.
187
FAX TX Priority -
This SP determines whether pushing the off-hook button will interrupt a RCG-M transmission
in progress to open the line for fax transaction. This SP can be used only if SP5816 164 is
set to "0".
[0 or 1/ 0 / - ]
0: Disable, 1: Enable
200 Manual Polling - Executes the manual polling.
System SP5-xxx
267
3
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA