Ricoh DDP70, Maintenance Manual

Page: 62 / 137

Troubleshooting
5-13
M M L 0 0
5.2.5. E1D0 to E1D3 FNS 1 PAPER LEAD JAM 1 to 3
E1D8 FNS 1 PAPER LEAD JAM 5
E1D5 to E1D7 FNS 1 PAPER TRAIL JAM 1 to 4
E1D9 FNS 1 PAPER TRAIL JAM 5
PRIMARY FACTOR; E1D0: Paper did not arrive at the FIN Entrance Sensor.
E1D1: Paper did not arrive at the Paper Exit 2 Sensor.
E1D2: Paper did not arrive at the Stacker Conveyance Sensor.
E1D3: Paper did not arrive at the Paper Exit 1 Sensor.
E1D5: Paper did not depart from the Paper Exit 2 Sensor.
E1D6: Paper did not depart from the Stacker Conveyance Sensor.
E1D7: Paper did not depart from the Paper Exit 1 Sensor.
E1D8: Paper did not arrive at the Sub-Tray Paper Exit Sensor.
E1D9: Paper did not depart from the Sub-Tray Paper Exit Sensor.
Note: E1D3 is detected on Staple mode of the following paper.
Letter (LEF)
A4 (LEF)
B5 (LEF)
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. Paper jam occurs. 1. Paper jam occurs. Remove: Jammed paper
2. Foreign substance is on
the paper path. Remove: Foreign substance
3. Paper Guide is
dislocated. Check: Paper Guide and its
magnet.
4. Gate position is faulty. Check: Gate position
If the gate position is out of order,
adjust it.
E1D1: Paper Route Switching
Gate
Sub-Tray Gate
E1D2: By-Pass Gate
Paper Route Switching
Gate
Sub-Tray Gate
E1D6: By-Pass Gate
Paper Route Switching
Gate
Sub-Tray Gate
E1D8: Sub-Tray Gate
E1D9: Sub-Tray Gate
6.7.2, 6-30
6.7.1, 6-28
6.7.3, 6-32
6.7.2, 6-30
6.7.1, 6-28
6.7.3, 6-32
6.7.2, 6-30
6.7.1, 6-28
6.7.1, 6-28
6.7.1, 6-28
5. Solenoid is faulty. Replace: solenoid
If the solenoid does not operate,
replace it.
E1D2: Gate Solenoid (SD1)
E1D5: Paper Exit Opening
Solenoid (SD4)
E1D7: Paper Exit Opening
Solenoid (SD4)
E1D8: Sub-Tray Paper Exit
Solenoid (SD2)
3.4, 3-3
4.3.10, 4-15
4.3.10, 4-15
3.4, 3-3
6. Motor fault. Replace: Motor
E1D0: Conveyance Motor (M1)
E1D5: Conveyance Motor (M7)
E1D6: Stacker Entrance Motor
(M14)
4.3.7, 4-12
4.3.8, 4-13
3.4, 3-3